This can be something attached to the grill ike a stainless steel grill hood or the control panel or eve the tip of a screwdriver. We test the spark by placing the module against a pice if steel. Once the module is in the palm of your hand and the battery is installed properly - in this spark generation module the AAA battery is installed positive-end-down - we want to test the spark. Module with battery and button being tested for sparks.Īlways start using and testing the module with a new battery installed. We can do this from inside the barbecue but it is difficult to get-to and difficult to see.
#Battery pulse ignitor generator#
To test the module we want to see if it will spark when the spark generator is not attached to the electrodes. The spark generatpr is just a small and simple electrocal product and they do not last forever.
Sometimes humidity or moisture or excess heat or something can cause the module to stop working. This is the way to repair the ignition about 90 percent of the time.
.jpg "battery pulse ignitor")
Usually if the ignition is not working, we need to get into the lower fire box of the barbeque and clean the tips of the electrodes with a little degreaser and a small file or a little sandpaper. If the tip of the electrode or the steel next to the tip of the electrode has grease, marinade, dirt, etc on it then the spark does not have a clean place to spark against and it will not spark, will not ignite the gases. Porcelain and then continues through the porcelain to spark at its tip.
All in one spark generator module sparking against steel shelf
0 kommentar(er)
